The cutter can take you to analyze the deviation of the blade of the slitter.

Cutter blade is an important processing link in the production of cardboard carton. Therefore, if there is a deviation of the cutter blade, it will be directly affected.

The quality of cardboard and carton products and even the products produced are all junk. So we have to cut the blade according to the corrugated board.

The common deviation analysis is to reduce the waste in cardboard carton production.

The slit cutting blade of the slitter blade is skewed.

1. Improper adjustment of blade feeding and locating baffle of slitter blade.

2, the cutting blade has a section of blunt, and other knife line speed difference.

3. Improper adjustment of the guide wheel of the slitter blade.

4, the cutter blade is not properly fed.

The blade of cutting machine produces burrs.

1. The blade of the slitter is blunt and should be worn.

2. The cutter blade and cutter groove overlap too much.

3. The knife edge of the slitter blade is involved in paper edges and paper hair.

4. The gap between the slots of the slitter is too large, generally less than 2.5mm.

The indentation line of the slitter is easily broken.

1, the base paper is inferior.

2, the line is too deep.

Slitter blade indentation line is not straight:

1. The blade of cutting machine is too shallow, and the broken line is uneven, which affects the appearance of the box.

2, the slicing blade is skewed.

3. The upper and lower pressure wheel of the slitting machine is not adjusted.

The edge of the blade of the slitter is not vertical.

1. The angle of the cutter blade of the slitter is not correct.

2. The slitter blade is not in the center of the tool slot.

3. The cutting edge of the slitter blade is skewed.